Emergency Water Extraction in Marietta, GA
Standing water is the most urgent part of any water damage job. Every hour it sits, more of it moves into carpet pad, subfloor, drywall and insulation, where it takes days to dry instead of minutes to remove. Extraction gets the bulk of it out first.
Until the line opens, email info@mariettawaterdamagega.com and say what happened and where.
Last updated November 16, 2026
When extraction is the first job
If you can see water on the floor, hear it squelch under carpet, or find it pooled in a basement, extraction comes before anything else. In Marietta homes the usual sources are a burst supply line, a water heater that let go, a washing machine hose, a backed-up floor drain, or rainwater that came in through a basement wall or window well.
Before the restoration company arrives, stop the source if you can do it safely, keep out of water that is near outlets, and move what you can onto dry ground. Do not use a household vacuum on standing water.
What the technician brings
- Submersible pumps for deep water, typically in basements and crawl spaces.
- Portable or truck-mounted extractors with wands for carpet and hard floors.
- Weighted or ride-on extraction tools that squeeze water out of carpet pad.
- Moisture meters and thermal cameras to find where the water travelled under baseboards and into the next room.
Clean, gray or black water
The type of water decides how much material can stay. Water from a supply line or a water heater starts out clean. Water from a dishwasher, a washing machine or a toilet tank is gray. Sewage and floodwater that came in from outside are black and carry bacteria and debris. Clean water left for a couple of days can degrade too, which is another reason to extract early.
Why speed matters
The EPA advises drying wet building materials and furnishings within 24 to 48 hours to prevent mold growth. Extraction is what makes that window realistic.
Source: U.S. EPA, A Brief Guide to Mold, Moisture and Your Home.
After the water is out
Extraction removes the water you can see. The rest is in the structure, and it comes out with air movers and dehumidifiers over the next several days. The technician will usually pull baseboards or drill small holes at the bottom of walls where readings stay high, rather than cutting out whole sheets of drywall. See structural drying and dehumidification.
Insurance
Most homeowners policies expect you to take reasonable steps to limit further damage, and getting water out promptly is one of them. Keep the extraction invoice and photos. Until our phone line opens, email info@mariettawaterdamagega.com while the phone line is being set up.
Extraction in basements, upper floors and slabs
Where the water is changes the job. In a Marietta basement, water collects on the low side of the room and under carpet that was laid straight onto concrete; the crew usually pumps first, then extracts the carpet and pulls the pad so the slab can breathe. On an upper floor, water from a bathroom or laundry runs through the subfloor and into the ceiling of the room below, so the technician checks the floor beneath before calling the job done. On a slab-on-grade home, water spreads under laminate and vinyl plank and along the bottom plates of walls, which is why baseboards often come off.
Ask the crew to show you the meter readings at the edge of the wet area. The visible puddle is rarely the whole story, and the readings are what decide where to set the drying equipment.
What you can safely do before the crew arrives
- Stop the source and switch off power to wet rooms from a dry spot.
- Lift curtains and bed skirts off wet floors and move furniture onto blocks or foil.
- Take books, papers and photos to a dry room; lay them flat.
- Leave wet carpet in place for the technician to assess rather than pulling it up yourself.
Marietta homeowners ask
Can I use a shop vac instead?
For a small spill on a hard floor, yes. For water across carpet or in a basement, a shop vac removes surface water but leaves the pad and subfloor saturated. Truck-mounted or portable extractors pull water out of carpet and pad with far more suction, and weighted extraction tools press it out of the pad.
Will the carpet have to be thrown away?
Not always. Carpet soaked by clean water from a supply line can often be extracted and dried in place, though the pad is usually replaced. Carpet soaked by sewage or outside floodwater is normally removed because it cannot be cleaned reliably.
How long does extraction take?
For a typical room, an hour or two. A finished basement or several rooms can take most of a day. Drying afterwards takes several more days with equipment running.
Sources
Ready when you are
Water you can see is the easy part. Get it out before it becomes water you can't.
- A local company measures the moisture before anything is torn out
- You get the scope and the price directly from that company
- Our referral is free; the contractor is independent
Until it opens, email info@mariettawaterdamagega.com.